Press the key on the CNC panel. The parameters will begin streaming to your computer. Restoring Parameters (Reading) Enable PWE (set to 1) as outlined in the section above. Put the machine into EDIT mode. Press the SERVICE or PARAM key.
Go to parameters via IPL. Enter parameter 0 to unlock write enable.
This is the troubleshooting section. When the machine alarms out with "OT (Over Travel), "SV (Servo), or "300 (APC)," the manual tells you which diagnostic bit to check. Fanuc 10m Parameter Manual
The internal memory of a Fanuc 10m control relies on a lithium battery back-up system. If the battery dies while the machine is powered off, Creating a digital backup is mandatory preventative maintenance. Backing Up (Punching) Parameters to a PC:
The Fanuc 10M was modular. You paid for options: Helical interpolation, macro B, rigid tapping, and DNC. Press the key on the CNC panel
: These are the hex-coded option parameters usually loaded via the IPL (Initial Program Loader) screen. specific parameter description
Baud rate selection (commonly set to 10 for 4800 baud or 11 for 9600 baud). 2. Axis and Coordinate System Settings Put the machine into EDIT mode
| Parameter 5110 Value | Handshake Type | |----------------------|----------------| | 3 | Xon/Xoff (software) | | Other values | Hardware handshaking (RTS/CTS) |