Media Converter In Cisco Packet Tracer Link [2021] Page

Place a , a Switch-PT , and a 2811 Router on the workspace.

What is the of your topology (e.g., spanning a long distance, lab assignment)?

In Cisco Packet Tracer, a is a device that allows you to connect two different physical media types — typically Copper (Ethernet) and Fiber Optic — without needing a switch or router with mixed ports. media converter in cisco packet tracer link

Assign an IP address in the same subnet (e.g., 192.168.1.20 , subnet 255.255.255.0 ). Return to the > Desktop > Command Prompt . Type ping 192.168.1.20 and press Enter.

If you are using the fiber ports on Cisco switches in Packet Tracer, remember that fiber ports usually operate at . Place a , a Switch-PT , and a 2811 Router on the workspace

For a simple, unmanaged media conversion simulation that requires zero software configuration, use a generic hub. : Drag a generic Hub-PT onto your workspace.

Connect your local copper switch to the router's built-in RJ45 port. Assign an IP address in the same subnet (e

(Note: Switch-B must also have a fiber port. If you used a standard 2960 switch for Switch-B, you will need to add a GigabitEthernet SFP fiber module, or use another PT-EMPTY switch with a fiber module installed.) Alternative Method: Using Routers with SFP Modules

: Allows legacy or copper-only devices (like some older switches or PCs) to connect to a high-speed fiber backbone. How to Use the Media Converter

The Media Converter in Cisco Packet Tracer has several real-world applications:

You now have a device that accepts a standard Copper Ethernet cable (RJ-45) on one side and a Fiber Optic cable on the other side. Method 2: Using a Modular Router (Cisco 1941 or 2911)