1. APP Installation

The APP has two versions of Android system and IOS system, both support Chinese and English bilingual..

IOS users can search"Enerkey“ in the Appstore, Please see below photo.

Android users can download it from Baidu web disk; Or go to our company website download center to download the installation package.
Baidu web disk link：https://pan.baidu.com/e/1r-HFiB8KfPVy5SplVK1iTA
Company website：http://www.enerkey.cn/cate/128.html This sub-string is a standard category identifier or

2. APP Use

After downloading the APP, you must enable the location and location information and allow the APP to use the location information. If the location is not enabled, the equalizer cannot be searched and the device cannot be connected. Before powering on the power supply, check whether the equalizer is properly connected, whether the power supply for the equalizer is within the required range, whether the equalizer is properly placed, and whether there is short circuit on the circuit board.

Please see below steps for how to use it:

1).  connect the device, as shown below; After the unconnected device enters the APP, the system will automatically start scanning the device.

2). After the connection is successful, start the balance switch, You can also modify the parameters first (enter the password for the first time).

3). According to the battery type and battery string number, change the parameters , as shown in the figure below;

4). After setting the required parameters, you can monitor the parameters of each monomer from the "Status" or "Alarm" page;

5). Disconnect the device or replace the connected device.(If you want to maintain equilibrium, do not close the equilibrium)
Special note: Turn off the "balance switch" or remove the power/battery pack, and the equalizer will stop running.

Finally, the steps for viewing device information and changing device password are attached, as shown in the figure below.

Notice:

The equalizer defaults to 24S for the first time, so when you use it for the first time, the connected battery pack is not 24S, and the fault indicator will light up, which is a normal phenomenon. Because the number of strings set in the APP is inconsistent with the number of battery strings actually connected, in this case, modify the battery parameters after the connection is successful and then enable the balance. When a fault occurs, the balance cannot be enabled. Here is a systematic approach to handling such