Check if your DMX chain requires a 120-ohm DMX terminator plug at the data output of the very last fixture in your line to eliminate signal reflection.
Press and hold the Program button for approximately 3 seconds until the Program indicator flashes. Creating a Scene Enter Program mode. Select the Scanner button(s) you want to use.
Select the next scene for your sequence and press again. Repeat this process for up to 240 steps in a single chase. disco 240 dmx controller manual
This is the section where most users get stuck, and the manual often fails to provide a lifeline. Programming a generic DMX board is counter-intuitive; you have to clear memory, set sliders, record a scene, clear sliders, set new sliders, record scene two, etc.
Are you trying to program ?
Write a "fixture map" on paper: Channel 1 = Pan, Channel 2 = Pan Fine, Channel 3 = Tilt, Channel 4 = Dimmer, Channel 5 = Color, etc.
Select your desired sequence by pressing one of the buttons. Check if your DMX chain requires a 120-ohm
Select your desired programmed . The controller will now advance to the next step of the sequence each time the internal microphone detects a distinct low-frequency audio beat. Troubleshooting Common Issues
To prevent signal reflection that can corrupt your light commands, plug a 120 \, \Omega \mathbin/ 1 \, \textW terminal resistor into the DMX Output of the very last fixture in your chain. 3. Patching and Channel Assignment Select the Scanner button(s) you want to use
Press and hold the button for 3 seconds to save and exit. 4. Playback and Operation Modes
End of full manual text for the Disco 240 / DMX Operator 240 controller.