Crucial: Slide the rubber bumper cushions onto the bottom of the guide rods before adding any weight plates. Step 3: Weight Stack Installation
Disclaimer: This article is for informational purposes only and does not replace the official DP Dual Trac 20 assembly instructions manual PDF. Always refer to the original equipment manufacturer’s documentation for safety-critical procedures.
When attaching pulleys, do not fully tighten any bolt until all components in a single sub-section are in place. This 'loose assembly' technique allows for micro-adjustments to align the pulleys perfectly, eliminating any potential squeaking or friction. Assembly Instructions Dp Dual Trac 20 Manual Pdf
Attach the padded seat and backrest cushions using the provided hex bolts. Do not over-tighten, or you will strip the wood backing of the pads.
Secure them using the long carriage bolts, inserting them from the bottom up to protect your flooring. Slide the rubber end caps onto the stabilizer bars. Step 2: Vertical Uprights and Weight Guide Rods Crucial: Slide the rubber bumper cushions onto the
This is where the weight stack comes into play.
Remember: A correctly assembled DP Dual Trac 20 will provide years of reliable service. Rushing the assembly or using incorrect instructions is the number one cause of performance issues. Keep the manual PDF on your smartphone or tablet during assembly – and never discard the digital copy. When attaching pulleys, do not fully tighten any
Incorrect cable routing is the number one cause of stiff operation, frayed cables, and component damage. The DP Dual Trac 20 typically utilizes a two-cable or three-cable system.
Direct the cable backward through the at the base of the upright mast.