V2000-c Rfid Access Control User Manual Now

Release the button after hearing a series of short beeps. The Master Code reverts to factory defaults. 6. Troubleshooting Common Issues Potential Cause Recommended Action No power supply output

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

The V2000-C is a standalone access control system designed for single-door entry points. As an all-in-one device, it integrates a keypad, an EM (125kHz) RFID card reader, and the main controller board into a single unit. It is ideal for securing offices, homes, warehouses, and other facilities that require controlled access for up to 1000 users.

This manual serves as a definitive resource for physical setup, initial programming, wiring layouts, and regular administration. Users looking to save a copy can access the official Obohands V2000-C Product Downloads for direct digital documentation. 1. Technical Specifications and Hardware Overview V2000-c Rfid Access Control User Manual

In programming mode, press 1 + Swipe Card + # . Repeat for multiple cards.

End of the V2000-c RFID Access Control User Manual.

Before beginning installation, ensure your electrical infrastructure matches the unit's operating requirements: 2,000 cards/PIN codes Operating Voltage: 12V DC ±10% Card Type: EM (ID) Card (125 kHz format) Reading Distance: 3–8 cm Current Draw: Lock Output Load: Max 3A Door Relay Time: Adjustable from 1 to 99 seconds Release the button after hearing a series of short beeps

For a : Connect the power supply +12V to the lock positive terminal. Connect the lock negative terminal to the V2000-C NC (Yellow) wire. Loop the V2000-C COM (White) wire back to the power supply GND.

Initialisation is the process of resetting the V2000-C. It is typically performed if you have forgotten the system's programming password (master code).

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Can’t copy the link right now

Always turn off the 12V DC power supply before splicing any wires to prevent short circuits. Lock Wiring:

Locate the button or jumper pins on the main circuit board inside the housing.