EZVIZ no longer supports Internet Explorer or earlier versions, and the site may not behave as expected. Please upgrade to a newer browser.
Disconnect the USB cable, remove the battery, reinsert it, and power on the phone. 🔍 Troubleshooting Common Errors
button (or the 'C' key on older SE models) while connecting the USB cable to your PC. Start Flashing
Click the button. The process will take a few minutes. Do not disconnect the phone, as this can permanently break (hard-brick) the device. Step 7: Finalize
Note that the initial boot up after a fresh flash can take up to 3–5 minutes. Troubleshooting Common Errors Device Not Recognized sony ericsson ck13i flash file z full
Extract the downloaded file to a dedicated folder on your computer. Install or the necessary flashing software. Phase 2: Flashing Procedure
Use SEtool2 Lite , Sony Ericsson Omnius , or FlashTool (legacy version configured for Sony ODM/Feature phones).
Remove the battery for 5 seconds, then reinsert it (do not turn the phone on). Disconnect the USB cable, remove the battery, reinsert
Summary
Once the status bar shows "Ready" or "Finished," remove the phone. 4. Finalization
Apps are crashing, or the touchscreen is unresponsive. The process will take a few minutes
The software will begin writing the system blocks ( APP , FS , and Cust ) to the phone's flash memory.
Power off the phone completely. Remove and reinsert the battery for a clean state. Enter Flash Mode
Store