Xentry Passthru Openport 2.0 → (INSTANT)

At its core, this setup pairs the hardware with the Xentry Passthru software. It is an SAE J2534-compliant solution that allows a personal computer to communicate with the electronic control units (ECUs) of most modern Mercedes-Benz vehicles.

Comprehensive Guide to Xentry Passthru with Tactrix Openport 2.0 Xentry Passthru Openport 2.0

A: No. The Openport 2.0 will only work with the Xentry Passthru version. If you have installed the OpenShell version, your Openport 2.0 will not be recognized as a valid multiplexer. At its core, this setup pairs the hardware

This setup does not support older Mercedes models utilizing the 38-pin diagnostic connector (pre-2002 models) or vehicles utilizing older K-Line communication protocols. It works best on CAN-Bus vehicles (roughly 2006 to present). The Openport 2

A few caveats

It cannot communicate with older Mercedes-Benz vehicles that rely on K-Line communication or the old 38-pin round diagnostic connector.

When purchasing a clone, be aware of potential issues. Some clones have a known OBD power supply bug where the device draws all power from the USB cable instead of the OBD port, leading to unreliability.