The middle button controls how the device processes and reports data:
: Use the one-key hold function to freeze the current reading for easier viewing. Technical Specifications Specification Electric Field Range 1V/m – 1999V/m Magnetic Field Range 0.01μT – 99.99μT (0.1mG – 999.99mG) Measurement Bandwidth 5Hz – 3500MHz Sampling Time Approximately 0.4 seconds Display 3-1/2 digit backlit LCD Battery Built-in 3.7V rechargeable lithium battery Auto-Off Powers down after 5 minutes of inactivity Proper Usage and Maintenance
: Short press to display the real-time average measurements.
: Use AVG for stable radiation sources and VPP for fluctuating spikes. 3. HOLD / BEEP Button Short Press : Freezes the data on the screen. Long Press : Turns the audible alarm buzzer ON or OFF. 🚀 Step-by-Step Operating Instructions Step 1: Powering On the Device
). Ensure your device is set to your preferred regional metric. Step 3: Approaching the Radiation Source erickhill rt-100 user manual
, ensure the device is fully charged using the included USB cable.
You can obtain a copy of the ErickHill RT-100 user manual through the following channels:
: Turns the meter on. If the meter is already active, a short press freezes the current reading on-screen ( Data Hold mode). Press again to unlock. Long Press : Turns the detector off. Average/Peak Mode & Buzzer Switch
: Pass your hand briefly over the top sensor to verify the screen registers structural movement. 2. Taking a Measurement Hold the meter securely near its base. The middle button controls how the device processes
: Short-press the "H" or "HOLD" button to lock the current reading on the screen; press it again to resume live measurement.
Right Light Off, Middle Light Off, Left Light Off.
The company stands behind its products, often offering a and lifetime technical support for their devices. This means you can contact their customer service directly for help with any technical questions, replacement parts, or guidance.
: Hold the device and slowly approach the radiation source using the front sensing area. 🚀 Step-by-Step Operating Instructions Step 1: Powering On
* EMF Meter. * Nuclear Radiation Detector. * Infrared Thermometer. * Wood Moisture Meter. Wood Moisture Meter. ERICKHILL RT-100 EMF Meter
(hold for approximately 2–3 seconds) the Power button to turn off the detector. Alternatively, the device will automatically shut down after 5 minutes of inactivity.
: Walk outside your property to test the strength of external overhead electrical grids. ⚠️ Limitations: What It Cannot Measure