_verified_: Din 53357 Pdf

When a client asks for a DIN 53357 PDF , verify whether they explicitly require the German method or if they accept ISO 1817. Many modern testing houses have replaced DIN 53357 with ISO 1817, but older specifications still cite the DIN number.

The core piece of equipment for the DIN 53357 test is a tensile testing machine that meets the requirements of DIN 51220 and DIN 51221. The machine's measuring range must be selected such that the average separation force does not fall within the first fifth of the device’s measurement range. Additionally, a special clamping device for peel tests is required, with a defined peel roller (so-called "German Wheel Peel Fixture") that complies with DIN 53357-B.

: Evaluating multi-layer barrier films used for food and medical packaging to safeguard against contamination.

Typically 50 mm for composite sheets; 15 mm for thin multi-layer films. Method B (Split Test): din 53357 pdf

Method B was specified for materials that do not allow clean separation of the layers, e.g., due to high bond strength or brittle substrates. This procedure works by preparing specimens 250–300 mm long and 15 mm ± 1 mm wide. A "cleavage" is initiated by applying a solvent or via a sharp notch in order to forcibly separate the layers at the start of the test.

A strip of specified dimensions is cut from the sample material.

Attempts to find a direct international (ISO) replacement have been problematic. Standards like DIN EN ISO 2411 (for rubber-coated textiles) and DIN EN ISO 11339 (for adhesives) are deemed unsuitable because they specify different sample widths and do not address the peel angle crucial for film adhesion measurements. As a result, many industries continue to use the withdrawn DIN 53357 in their internal specifications. When a client asks for a DIN 53357

The primary objective of the test is to measure the mechanical force required to separate multi-layer flexible structures, such as: Coated fabrics and textile materials. Multi-layer composite packaging films. Pressure-sensitive adhesive (PSA) tapes and labels.

A strip of laminate or coated plastic is pre-separated at one end.

Measuring the adhesion of coatings on outdoor billboard and banner fabrics. The machine's measuring range must be selected such

Often utilizes a specialized German Wheel Peel Fixture . This method is designed to evaluate the bond between a coating or laminate and a more rigid substrate, ensuring precise alignment and accurate force measurement during the peeling process. Equipment and Parameters

Replacement amendments. This document has been replaced by: DIN 55543-5:2017-10 . DIN 53357 - 1982-10

: The average bond strength is derived mathematically by distributing ten equal measurement points across the physical separation distance.

Often recommended for similar adhesion testing.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. DIN 53357 - 1982-10