Fife Csp-01 Manual //top\\ Jun 2026

If you are looking for more information, you can also search for online to download the complete technical documentation. CDP-01 Additional Instruction Manual

: If sensors move in the wrong direction during an edge search, the manual instructs users to verify the "Guide Direction" settings.

controller, edge sensors (like the SE-34), and an actuator or offset pivot guide. Fife Csp-01 Manual

Toggles the "Lockout" or deadband function. If the sensor loses the web (e.g., a tear), the system enters a safe "lock" state.

While the manual focuses on electronics, veteran technicians know that 70% of "CSP-01 problems" are actually mechanical. Here is a diagnostic table derived from manual maintenance sections: If you are looking for more information, you

Return the material to the physical center of the sensor (50% coverage). The system's indicator lights or bar graph should show a stable, non-blinking center signal.

This section provides the physical dimensions, environmental ratings (e.g., IP54), and electrical requirements. You will reference this to ensure your control cabinet has adequate cooling and clearance. Toggles the "Lockout" or deadband function

| Common Model | Description | | :--- | :--- | | CSP-01-06 | Standard guide control, often sold as a used unit | | CSP-01-13 | Edge guide controller with 125 VA power supply | | CSP-01-MVRC | Variant with ESU11 board and 140 VA power supply | | CSP-01-06RC | Web guide controller for lateral web positioning | | CSP-01-06 ESU-01 | Sensor guide controller for web alignment |

Setting the system gain is necessary to prevent "hunting" (over-correction) or sluggish response. This is often adjusted while the web is at a standstill. Fife Csp-01 Manuall EXCLUSIVE - Wakelet

| Specification Category | Detail / Value | | :--- | :--- | | | | | Supply Voltage | 110 / 115 V AC or 220 / 230 V AC (Check your model variant) | | Power Consumption | 125 VA (Common), up to 140 VA for heavy-duty models | | Frequency | 50/60 Hz | | Compatibility & Expandability | | | Backward Compatibility | Compatible with older Fife processors: CDP-01, SV-01, A9 | | Upward Compatibility | Fully compatible with newer D-MAX network operator interfaces and OI-N/ OI-B units | | Supported Actuators | CDP-01, CSP-01, GAB-1, GAB-2-3-A | | Physical & Environmental | | | Mounting | Standard industrial DIN-rail or panel mount (check your model specifics) | | Weight | Approx. 2 lbs (0.9 kg) to 9.77 oz (0.28 kg) for the operator interface | | Operating Temperature | 32°F to 140°F (0°C to 60°C) | | IP Protection | IP54 (Bezel), IP40 (Wall Mount) for compatible D-MAX operator interface |

Press the Automatic button once to save these parameters into the unit's local memory. Preventive Maintenance Checklist